M-48: Storing Settings to a Memory

The M-48 contains 16 memory locations that can store and recall M-48 settings.

Storing Settings:

1. Press the [STORE] button. The [STORE] button will light, and Store mode will be on. At the same time, all [SOLO] buttons will start blinking. The [SOLO] button of the current memory number will be lit.
   * Store mode will turn off if you press the [STORE] button once
   again.
   * The [1-8] or [9-16] button will blink to indicate the range of
   memory numbers shown.
2. Press the [1-8] or [9-16] button to select the desired range of memory numbers.
3. Press the [SOLO] button of the memory number into which you want to store the current settings. The [STORE] button and the [SOLO] button you selected as the storage destination will blink.
4. Press the [STORE] button to execute the Store operation. You can also execute the Store operation by pressing the blinking [SOLO] button. When the Store operation has been completed, the [STORE] button will go out and Store mode will turn off.
   * If you decide to cancel without storing, press any button that’s not blinking.
   * Storing will take approximately two seconds. During this time, the M-48 will not be operable.

Recalling Settings:

1. Press the [RECALL] button. The [RECALL] button will light, and Recall mode will be on. At the same time, all [SOLO] buttons will start blinking. The [SOLO] button of the current memory number will be lit.
   * Recall mode will turn off if you press the [RECALL] button once again.
   * The [1-8] or [9-16] button will blink to indicate the range of memory numbers shown.
2. Press the [1-8] or [9-16] button to select the desired range of memory numbers.
3. Press the [SOLO] button of the memory number that you want to recall. The [RECALL] button and the [SOLO] button you selected as the target of the recall will blink.
4. Press the [RECALL] button to execute the Recall operation. You can also execute the Recall operation by pressing the blinking [SOLO] button. When the recall has been completed, the [RECALL] button will go out and Recall mode will turn off.
   * If you decide to cancel without recalling, press any button that’s not blinking.