AX-Edge: Initializing and Restoring the Factory Default Settings

The following procedure will clear the internal memory and reload the factory settings:

(CAUTION!!!!: All USER information will be lost!!! Be sure to back up any information you wish to keep!!!)

1. Press the MENU/WRITE button.
2. Use the cursor </> buttons to select “UTILITY,” and then press the ENTER button.
3. Use the cursor </> buttons to select “FACTORY RESET,” and then press the ENTER button.
4. Press the ENTER button.
5. To execute, press the ENTER button once again.
6. When the LCD display indicates “Completed.” turn the AX-Edge’s power off and on again.

1. While holding down the VARIATION INC/+ + DEC/- plus TONE
7 / ORGAN/CLAVI) buttons and turn on the AX-Synth.

NOTE: The display will show the "FCt" message and the WRITE button will begin flashing.

2. Press the WRITE button to load the factory settings.

NOTE: All indicators will begin flashing.

(3) Wait until the "dne" message appears in the display,
then switch the AX-Synth off, wait a few seconds, and switch it back on.

Note: Never switch off the AX-Synth while the WRITE button is still lit, doing so may damage the unit.