1. While holding down the [LOAD] button in the right side (R channel) of the browser section, and press the [POWER] switch to turn on the
power.
The DJ-505 is in system setting mode, and the [START/STOP] button of the TR-S section is blinking.
2. Press the TR-S pad or button that corresponds with the setting you want to make.
The display shows the current value.
PAD [11] Margin at both ends of cross fader 0, 1–10 (default in Bold)
Specifies the margin at both ends of the cross fader. Higher values increase the margin,
providing more play at each end of the cross fader.
3. Use the [VALUE] knob to change the value of the setting.
4. When you’ve finished making settings, press the blinking [START/STOP] button.
After a few seconds, the display shows “CONp.”
5. Turn the DJ-505’s power off and then on again.