OD-200: Factory Reset (Initialization)

Below are the Steps to reset the OD-200 back to its factory-set state.
Note: Performing a Factory Reset will permanently erase all user/custom memory locations and settings. Be sure to write down any custom settings you wish to keep prior to performing the reset. The current installed firmware version will not be affected by the reset procedure. If you have recently performed a version update on the OD-200, it's recommended to perform a Factory Reset immediately after the firmware update process. 

1. Start with the OD-200 powered OFF.
   
2. While holding down the [ON/OFF] and [MEMORY/BOOST] footswitches, insert a 1/4" TS mono guitar/instrument cable into the INPUT jack, to power ON in Factory Reset mode.
   The display will indicate -“FCt” = Factory Reset
   
3. Release the [ON/OFF] and [MEMORY/BOOST] footswitches, and then press and release the [MEMORY/BOOST] footswitch.
   The display indicates “Sur”= Sure
   If you decide to cancel the reset, press the [MEMORY] button.
4. Press the [MEMORY/BOOST] footswitch again to execute the Factory Reset.
   The Memory/Boost LED and display will flash multiple times during the reset procedure.
   
5. When the display indicates “F In,” turn the OD-200's power OFF, and then ON again.