DD-200: Factory Reset (Initialization)
Below are the Steps to reset the DD-200 back to its factory-set state.
Note: Performing a Factory Reset will permanently erase all user/custom memory locations and settings. Be sure to write down any custom settings you wish to keep prior to performing the reset. The current installed firmware version will not be affected by the reset procedure. If you have recently performed a version update in the DD-200, it's recommended to perform a Factory Reset immediately after the firmware update process.
1. Begin with the DD-200 powered off.
2. While holding down the [ON/OFF] footswitch and [MEMORY/TAP] footswitch, turn ON the power (insert a guitar/instrument cable into the INPUT A jack) -
The display indicates “FCt” = Factory Reset
3. Press and release the [MEMORY/TAP] footswitch.
The display indicates “Sur”= Sure
If you decide to cancel the reset, press the [MEMORY] button.
4. Press and release the [MEMORY/TAP] footswitch again to execute the FACTORY RESET.
5. When “F In” appears in the display, cycle the DD-200's power OFF, and then ON again.
The Factory Reset is complete.
Excerpt from the DD-200 Owner's Manual page 15: