EQ-200: Factory Reset (Initialization)

Below are the Steps to reset the EQ-200 back to its factory-set state.
Note: Performing a Factory Reset will permanently erase all user/custom memory locations and settings. Be sure to write down any custom settings you wish to keep prior to performing the reset. The current installed firmware version will not be affected by the reset procedure. If you have recently performed a version update in the EQ-200, it's recommended to perform a Factory Reset immediately after the firmware update process. 

1. Begin with the EQ-200 powered off.
2. While holding down the [ON/OFF] footswitch and [MEMORY] footswitch, turn ON the power (insert a cable into the INPUT A jack).  
   The display indicates “FACTORY RESET.”
3. Release release both footswitches, and then press and release the [MEMORY] footswitch. - The display indicates “ARE YOU SURE?”
   If you decide to cancel, press and release the [ON/OFF] footswitch.
4. Press and release the [MEMORY] footswitch. 
   The Factory Reset is executed.
5. When the display indicates “COMPLETED,” turn the EQ-200's power OFF and ON again.