To record your performance, use the following options.
Recording to a DAW software:
By connecting the TD-07 to your computer via USB cable commercially available, you can send and receive MIDI messages and audio signals. Select "TD-07" as the input source for the MIDI or audio track you want to record on.
- To transmit and receive audio signals as USB AUDIO, the USB driver must be installed. Set the USBDrv to "VENDOR," and turn the power off and on again, then install the USB driver. No USB driver installation is required if it is only for transmitting and receiving MIDI messages.
- The setting procedure may differ depending on the software. Refer to the instruction manual of the software you are using.
External audio input signals cannot be sent to a computer via USB audio.
To record audio mixed with external audio input signals and your performance, make the following connections.
- The audio interface and audio cables in the illustration are just a few examples. Use an audio cable (commercially available, non-resistant type) to match the audio interface you are using.
Recording to an external recorder
Connect the OUTPUT/PHONES jack to the audio recorder's INPUT jacks using an audio cable.
- Use an audio cable that does not contain a built-in resistor.