Follow the steps below to set up the instrument.
What you’ll need besides the TAIKO-1 and stand
- String (1 m) × 3
- Disconnect all connection cables such as the AC adaptor and trigger cables.
- Remove the sound module of the TAIKO-1.
- Leave the rubber rings on the sound module.
- Thread the string through the belt on each pillar of the three-pillar stand, and tie a string into a loop (three places). - Hook the string loops onto the rods of the TAIKO-1.
- Place the pad so the protrusions on the pad face towards you.
- Each string loop should hook onto two rods.
- Attach the sound module. - Attach the sound module so that it is a little to the right from the center, so that the buttons are easier to operate.
View from the front (player’s side)
- Connect the pad and sound module with the included trigger cable (0.2 m).
Pad: TRIG OUT jack
TAIKO-1: TRIG IN 1 jack
- Do not connect the sound module to the lower pad.
The following video explains how to set up the instrument.
Attaching the Instrument to the Stand Roland TAIKO-1 #02