Aerophone Pro AE-30: How do I recall a desired scene using the numbered pedals on the FC-300?

Perform the following procedure.

- For details on the MSB, LSB and PC values for each scene, see the “AE-30 Scene List.”
- Using the following steps, we’ll use the numbered pedals to call up “01: Synth Hard Lead - 01AE Hard Lead” (MSB: 85, LSB: 64, PC: 1) as an example.
- To recall scenes in order, see the related Q&A, “What can you do when you connect a MIDI foot controller to the MIDI IN connector?”.

1. Connect the MIDI IN connector of the AE-30 to the MIDI OUT connector of the FC-300.
2. On the FC-300, press the [MODE] button to switch the unit to “PATCH” mode.
3. Use the [▼] [▲] pedals and the numbered pedals (1/6–5/10) to select the number you want to set.
4. Use the PARAMETER [<] [>] buttons to select “PATCH:On MIDI,” and press the [WRITE] button.
5. When “Edit MIDI” appears, press the [WRITE] button.
6. Use the PARAMETER [<] [>] buttons to move the cursor to the right of the message number, and use the VALUE [▼] [▲] buttons to select “CC.”
7. Use the PARAMETER [<] [>] buttons to move the cursor to “CC#***,” and use the VALUE [▼] [▲] buttons to select “000.”
8. Use the PARAMETER [<] [>] buttons to move the cursor to the “VAL***,” and use the VALUE [▼] [▲] buttons to change the MSB value to “85.”
9. Use the PARAMETER [<] [>] buttons to move the cursor to the message number, and use the VALUE [▼] [▲] buttons to change the number to “002.”
10. While referring to steps 6?8, specify a value of “032” for step 7 and an LSB value of “64” for step 8.
11. Use the PARAMETER [<] [>] buttons to move the cursor to the message number, and use the VALUE [▼] [▲] buttons to change the number to “003.”
12. Use the PARAMETER [<] [>] buttons to move the cursor to the right of the message number, and use the VALUE [▼] [▲] buttons to select “PC.”
13. Use the PARAMETER [<] [>] buttons to move the cursor to “PC#***,” and specify a value of “1” for the PC.
14. Press the [EXIT] button a number of times to return to the top screen of PATCH mode.
15. Press the [WRITE] button.
16. Check the save destination patch number and press the [WRITE] button.
    - To edit the numbered pedal to assign, use the VALUE [▼] [▲] buttons to select the number.
17. When “Sure?” appears, press the [WRITE] button again.
18. Press the numbered pedal you set to confirm that the scene is recalled.