EV-1-WL: Adjusting the Pedal Response and Effect Depth (Calibration)

Follow the steps below.

1. Push up on the pedal with your toes, without anything connected to the CTL1, 2 jacks, USB port and MIDI OUT connector.
2. Turn the [POWER] switch on while holding down the [Bluetooth] button.
   - The POWER indicator blinks green.
3. Push down on the pedal with your heel.
   - The EXP SW indicator blinks blue.
4. Press the [Bluetooth] button once more.
   - Calibration mode starts, and the EXP SW indicator blinks white.
5. With the pedal pushed down all the way with your heel, press the [Bluetooth] button.
   - This sets the pedal’s MIN position. The EXP SW indicator blinks yellow.
6. With the pedal pushed up all the way with your toes, press the Bluetooth button.
   - This sets the pedal’s MAX position. The calibration is now finished.
   - Turn the [POWER] switch OFF if you wish to cancel the calibration partway through.