The following article guides through connecting the R-07 to Bluetooth Speakers or Headphones for playback.
Note: The R-07 supports codecs SBC, Qualcomm® aptX™ audio and Qualcomm®aptX™ Low Latency audio. Check the documentation of the Bluetooth device to be sure that it supports one of these codecs.
Registering a Bluetooth device (Pairing)
“Pairing” is the procedure by which the mobile device that you want to use is registered on this unit (the two devices recognize each other). Once a mobile device has been paired with this unit, there is no need to perform pairing again. After the R-07 starts, it searches for the previously-connected device, and connects automatically.
- Place the Bluetooth device that you want to connect near the R-07, power-on the device, and
put it in pairing mode. For details, refer to the owner’s manual of your Bluetooth device. - Press [MENU] to access the “Menu” screen, use the cursor buttons to select “Bluetooth,” and then press the red record button to select it.
- Use the cursor buttons to select “Pairing Audio” and then press the red record button.
- Use the cursor buttons to choose “Yes,” and then press the red record button. The display indicates “Pairing...,” and this unit waits for a response from the Bluetooth device. When pairing succeeds, the display indicates “Completed.” and sound can be output from the Bluetooth device.
Connecting an already-paired Bluetooth device
MEMO
If you initialize the settings (p. 40), the existing pairing information is erased. You’ll need to pair your device again.
- Press [MENU] to access the “Menu” screen, use
the cursor buttons to select “Bluetooth,” and then press the red record button. - Use the cursor buttons to select “Connect Audio” and then press the red record button.
- Select the playback device and press the red record button.
- Use the cursor buttons to choose “Yes,” and then press the red record button.
The display indicates “Connecting...,” and this unit waits for a response from the Bluetooth device. When pairing succeeds, the display indicates “Completed.” and sound can be output from the Bluetooth device.
Checking which Bluetooth device you’re connected to
- Press [MENU] to access the “Menu” screen, use the cursor buttons to select “Bluetooth,” and then press the red record button.
- Use the cursor buttons to select “Information” and then
press the red record button. - Press [MENU] three times to return to the main screen.
Disconnecting a Bluetooth device
Use this procedure when you want to switch to a different Bluetooth device.
- Press [MENU] to access the “Menu” screen, use the cursor buttons to select “Bluetooth,” and then press the red record button.
- Use the cursor buttons to select “Disconnect Audio” and then press the red record button.
- Use the cursor buttons to choose “Yes,” and then press the red record button.
When disconnection succeeds, the display indicates “Completed.”