If you’ve installed the USB driver but can’t input/output audio data sent between the FANTOM-06 FANTOM-07 FANTOM-08 and your computer or other device, check the following points.
Specifying the USB driver
For the USB driver that’s used when connecting to your computer, use the “VENDOR” setting. Follow the steps below:
- Press the [MENU] button.
- Touch <SYSTEM>.
- Touch <GENERAL> tab.
- Select “USB Driver”, and set it to “VENDOR”.
- Press the [WRITE] button to save the SYSTEM settings.
- Turn the power off, then on again.
USB Audio Input Switch settings
Follow the steps below:
- Press the [MENU] button.
- Touch <SYSTEM>.
- Touch the <USB> tab.
- The USB tab on the SYSTEM screen appears.
- Use the cursor to select “USB Audio Input Switch,” and set the value to “ON.”
- Audio input from the connected device turns on. - Use the cursor to select “USB Audio Input Level,” and adjust the input level.
Adjusting the USB audio output
Follow the steps below:
- Hold down the [SHIFT] button and press the [PAN/LEVEL] button.
- The MIXER screen appears. - Select “OUT/USB” at the bottom of the screen.
- Move the cursor to “USB OUT” and adjust the output level.