You can specify individual MIDI channels for each part on the JUNO-X.
The MIDI channel for each part is set as shown below by factory default.
|
Part
|
Ch
|
|---|---|
| 1 | 1 |
| 2 | 2 |
| 3 | 3 |
| 4 | 4 |
| R | 5 |
Follow the steps below.
-
Press the [SCENE] button.
-
Press the [PART/FUNC] button to make it light up yellow, and press the [4] (PART 1)–[8] (PART R) buttons to select the part to set.
-
Use the [<] [>] buttons to select “SCENE PART EDIT”.
-
Use the [∧ SELECT V] knob to move the cursor to the “MIDI - Rx Ch” value.
-
Use the [- VALUE +] knob to select the receive channel for the part.
When the “Tx Mode” is “ON”, this channel is also used as the MIDI transmit channel. -
To save your edited settings, perform the Scene Write operation.
If you want to save a tone individually, use the tone write operation.