Beginning with system version 1.05, the VM-3100PRO's default R-BUS target mode was changed to "RPC-1." This ensures "out-of-the-box" compatibility with all components of the Studio Package bundle, which includes the RPC-1 PCI audio card. If you wish to use a DIF-AT with a VM-3100PRO equipped with v1.05 or later, the R-BUS target mode must be changed. Use the following shortcut procedure to change the VM-3100PRO's R-BUS target mode:
1. Hold SHIFT and press F4. "Load STAND ALONE Configuration" will be displayed.
2. Press ENTER/YES.
If desired, you may use this procedure to manually change the R-BUS target mode:
1. Press EXIT/NO twice to return to the main LEVEL METER display.
2. Press SYSTEM.
3. Press F1-F4 ON/OFF.
4. Press F2 [MIDI].
5. Cursor down to highlight the "R-BUS Target" line.
6. Rotate the VALUE dial to select DIF/VSR.
7. Press EXIT/NO.
Depending on the type of device connected to the DIF-AT, further VM-3100PRO system settings will probably need to be made. Please refer to the "R-BUS Equipment Setting and Connection Guide" for setting instructions for your preferred device, or search the help desk for the appropriate DIF-AT entries.
NOTE: The VM-3100PRO system version is displayed on power-up.
1. Hold SHIFT and press F4. "Load STAND ALONE Configuration" will be displayed.
2. Press ENTER/YES.
If desired, you may use this procedure to manually change the R-BUS target mode:
1. Press EXIT/NO twice to return to the main LEVEL METER display.
2. Press SYSTEM.
3. Press F1-F4 ON/OFF.
4. Press F2 [MIDI].
5. Cursor down to highlight the "R-BUS Target" line.
6. Rotate the VALUE dial to select DIF/VSR.
7. Press EXIT/NO.
Depending on the type of device connected to the DIF-AT, further VM-3100PRO system settings will probably need to be made. Please refer to the "R-BUS Equipment Setting and Connection Guide" for setting instructions for your preferred device, or search the help desk for the appropriate DIF-AT entries.
NOTE: The VM-3100PRO system version is displayed on power-up.