M-300:: How to Setup an M-300 as FOH and an M-300 as a Broadcasting Mixer

REAC CONNECTION
Connect the FOH M-300's REAC B port to the Broadcast M-300's REAC A port.

FOH M-300 SETTINGS

1. Press the SYSTEM button and set the SAMPLING FREQ to a desired sample rate.
2. Press F2 (REAC CONFIG) and then press F1 (SETUP).
3. Move the cursor to the REAC SETUP section, select FOH (DEFAULT) and then press ENTER.

BROADCAST M-400 SETTINGS

1. Press the SYSTEM button and set the SAMPLING FREQ to match the FOH M-300.
2. Press F2 (REAC CONFIG) and then press F1 (SETUP).
3. Move the cursor to the REAC SETUP section, select MONITOR/BROADCAST and then press ENTER.

ASSIGNING CHANNELS

Now that the consoles are setup, the FOH M-300's input channel DIRECT OUTs can be used to patch out to its REAC B. These will be "seen" as inputs in the Broadcast M-300.
For example, if the FOH M-300 input channel's direct out is patched to REAC B out 32, this will be received and "seen" from the broadcast M-300 as REAC A in 32.

FOH M-300

1. Press the PATCHBAY button.
2. Press F2 (OUTPUT) and then F4 (REAC B).
3. Press the down arrow to scroll down until the input channels appear on the left (e.g. CH 1, CH 2, etc).
   
4. Cursor to a desired REAC B output for a channel and then press ENTER. An arrow will appear in the box indicating the channel's direct out is patched to the REAC B output above.
   
   After patching all channels is completed, each input channel's direct out point needs to be set:
5. Press the SEL button for each input channel and then set the DIRECT OUT on the screen to PRE EQ.
   
6. Repeat this for each input channel.

Broadcast M-300

1. Press the PATCHBAY button.
2. Press F1 (INPUT) and then F3 (REAC A).
3. Patch the REAC A inputs on the top of the grid to the desired M-300 channels on the left. As a reminder, the Broadcast M-300's REAC A inputs on the top of the grid are sourced from the FOH M-300's REAC B port.