After creating a sample you may decide to change the start and end point of the recording. The SP-303 can easily set new start and end points. Use the following procedure to set a Start Point and an End Point for a sample:
1. Press PATTERN SELECT so it is not lit.
2. Press the pad you want to edit. The pad will light and the sample will sound.
3. Press START/END/LEVEL so it is lit.
4. At the location where you wish to set the Start Point, press MARK. MARK blinks and "---" appears in the display.
5. At the location where you wish to set the End Point, press MARK again. MARK will light, indicating that the process is finished.
Note: If the setting was not made as desired, press the lit MARK button while the sound is still playing to make it go dark, and re-do the procedure.
1. Press PATTERN SELECT so it is not lit.
2. Press the pad you want to edit. The pad will light and the sample will sound.
3. Press START/END/LEVEL so it is lit.
4. At the location where you wish to set the Start Point, press MARK. MARK blinks and "---" appears in the display.
5. At the location where you wish to set the End Point, press MARK again. MARK will light, indicating that the process is finished.
Note: If the setting was not made as desired, press the lit MARK button while the sound is still playing to make it go dark, and re-do the procedure.