DJ-505: Returning to the Factory Settings (Factory Reset)

By performing a Factory Reset, the system settings and TR-S patterns stored in the DJ-505 will be restored to their factory-set state.

Follow the steps below to proceed:

1. While holding down the [LOAD] button in the left side (L channel) of the browser section, and press the [POWER] switch to turn on the power.
   The display indicates “FACT ,” and the [START/STOP] button of the TR-S section blinks.
   * If you decide to cancel the operation, turn off the power.
2. Press the blinking [START/STOP] button.
   Factory reset begins.
   When the display indicates “CPLT,” factory reset is complete.
   NOTE: Never turn off the power until the display indicates “CPLT .”
3. Turn the DJ-505’s power off and then on again.