You can enter system settings via the instruction below:
While holding down the [LOAD] button in the right side (R channel) of the browser section, and press the [POWER] switch to turn on the power.
The DJ-505 is in system setting mode, and the [START/STOP] button of the TR-S section is blinking.
Press the TR-S pad or button that corresponds with the setting you want to make. The display shows the current value.
Use the [VALUE] knob to change the value of the setting.
When you’ve finished making settings, press the blinking [START/STOP] button.
After a few seconds, the display shows “CONp.”
Turn the DJ-505’s power off and then on again.
For changing the Backspin length choose the 3rd pad from the Left channels performance pads.
Next use the [VALUE] knob from the TR-S section to choose from the following:
OFF
Backspin operation occurs according to the actual distance of rotation.
Short
Backspin operation is shorter than with the Normal setting.
Normal
Backspin operation occurs longer than the actual distance of rotation.
Long
Backspin operation is longer than with the Normal setting.