Connections
-
To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
-
The input/output jacks in the jack area are used for MONO mode. The input/output jacks that can be used are illuminated.
Red: Audio signal, Blue: Control signal -
The state of each input jack (connected or disconnected) is stored in memory.
Input jacks in which a plug is not inserted when settings are written are stored in memory as “disconnected jacks.” Even if a plug is inserted into a “disconnected jack” when that memory is recalled, the input signal from that jack is ignored (the jack blinks). This allows you to store different sounds that use various combinations of external devices (input jacks). To enable a blinking “disconnected jack,” unplug and reinsert the plug. -
Use patch cables with monaural mini-plugs to connect other equipment. The system will not work correctly if you use cables with stereo mini-plugs.
- If you’re playing via MIDI (or USB MIDI), disconnect any cables from the CV (IN) jack and the GATE (IN) jack. If a cable is inserted in the CV (IN) jack or GATE (IN) jack, playing via MIDI (or USB MIDI) is not possible (when using MONO mode).
CV IN Settings
Here’s how to specify the fine tune, key follow relative to the input voltage.
Adjusting the fine tune
- While holding down the [OSC TYPE] button, turn the [SELECT] knob. The display indicates the fine tune amount (Values represented by the jack LEDs).
Adjusting the key follow
- While holding down the [NOISE TYPE] button, turn the [SELECT] knob. The display indicates the key follow amount (Values represented by the jack LEDs).