Loading Backup Data (Backup Load)
This operation will load backup data (all data including sample banks and pattern banks) from the SD card.
NOTE: Once you execute the Backup Load procedure, all of your existing samples and patterns will be overwritten by the backup data as it is loaded.
- Hold down the [SHIFT] button and press the pad [5] (BACKUP LOAD).
The display will indicate “Lod,” and the pads to which backup data has been saved will blink.
MEMO- If the memory is protected (p. 21), the display will indicate “Prt” (Protected) and the backup load operation cannot be executed.
- If there is no backup data on the SD card, the display will indicate “ENP” and the backup load operation cannot be executed.
- Press a pad to select the backup data that you want to load.
The selected pad will light, and the other pads will go out.
The [REC] button will blink.
MEMO: If you decide to cancel, press the [CANCEL] button. - Press the [REC] button.
The [REC] button will light, and the backup load operation will be executed. During execution, the dot in the display will blink. When the blinking stops, the backup load operation has been completed.
NOTE: Never turn off the power while the dot is blinking. Doing so may destroy the SD card.