Formatting an SD Card
NOTE:
• When you format an SD card, all data on that card will be erased.
• Do not format the SD card included with the SP-404A
The SP-404A supports SD Cards up to 32gb
The included SD card contains preload data. All of this data will be lost if you format the included SD card.
Restoring the included SD card to the factory-set condition
To restore the SD card included with the SP-404A to its factory-set condition, refer to “Restoring the Factory Settings (Factory Reset)”
Formatting an SD Card
- While holding down the [CANCEL] button, press the [REMAIN] button.
The [BANK] buttons will blink, and the display will indicate “FNt.” - Press any one of the [BANK] buttons.
The [BANK] buttons will change from blinking to lit, and the [DEL] button will blink.
MEMO: If you decide not to format the card, press the [CANCEL] button. - Press the [DEL] button.
The [DEL] button will light, and formatting will begin.
During the formatting process, the dot in the display will blink.
When the blinking stops, formatting is complete.
NOTE:- Never turn off the power while the dot is blinking. Doing so may damage the SD card, rendering it unusable.
- Don’t modify or delete the files or folders that are created when an SD card is formatted. The SP-404A will not recognize the card correctly if you do so.