VERSELAB MV-1: Factory Reset

A factory reset on the VERSELAB MV-1 restores all system settings to their original factory defaults.

NOTE:
- If necessary, be sure to save your project before executing the factory reset.
- A factory reset does not affect any data stored on the SD card. If you want to erase all the data on the SD card, please perform a format operation.

Follow the steps below:

1. Hold down the [SHIFT] button and press the [SYSTEM] button.
   The UTILITY screen appears.
2. Use the [VALUE] dial to select “FACTORY RESET,” and then press the [VALUE] dial.
   A confirmation message appears.
   
   * To cancel the operation, press the [EXIT] button.
3. Use the [VALUE] dial to select “OK”, and then press the [VALUE] dial.
4. Once the message “Turn off power” appears, turn off this unit and then on again.

MEMO: Turn on the power while holding down the [CLEAR] button to perform a factory reset. When the unit restarts, a confirmation message appears.